Mike E January 18, 2021. The fuel cutoff switch, also known as the inertia switch on the 2015 ford transit is in the toe-board, which is right of the transmission hollow, on the passenger side. this switch is a safety switch on the car, which is designed to cut the fuel pump off in the event of a collision. this way if there is a fire or the On the 2008-2010 Ford F-250, This switch is located on the passenger’s side of the instrument panel. Open the front passenger door and remove the small access panel. Make sure to turn off your vehicle. Pushing in the Fuel pump shut-off (inertia) switch. Turn the ignition to the ON position (Do not turn the ignition to ‘START) and wait a few You could try that. Also, check the on dash code read out to see what it says. Ignition off. Press and hold trip reset button. Whilst still holding button in, switch on ignition. After a few seconds the gauges will do a sweep test and on the screen it will say 'GAUGE'. Press the trip button till it says DTC. Ranger. You can find the inertia switch, which is also known as the fuel pressure inertia switch (FPIS), on Your Ford Ranger's passenger foot area, under the dash, near the front edge of the carpet. When You pull back the carpet, You should immediately see the switch, which is a small, grey, box shaped plastic part, held in place with a small I am pretty sure all of the wires going to the fuel pump, also run along the floor right under the driver side door and up by the dash near the pedals and kick panel. 2015 Mustang GT - 6R80. True daily driver, 120k+ miles Curb rash, paint chips, worn seats, Paxton 2200SL w/ ID1050x, gen3 manifold. Turn the ignition switch to the off position. 2. Turn the ignition to the on position. In some instances the vehicle may not restart the first time you try to restart & may take one additional attempt." I scoured the manual, & there is no mention of a "switch" anywhere, that it is an automatic system. probably too late to help, but there it is. b7A9a. 1. Turn the ignition to the OFF position. 2. Check the fuel system for leaks. 3. If no fuel leak is apparent, reset the fuel pump shut-off switch by pushing down on the reset button. 4. Turn the ignition to the ON position. Pause for a few seconds and return the key to the OFF position. There's no physical switch for fuel cut off; there's a reset process, it's on page 42 of the owners handbook. It goes something like: turn the ignition key to MAR; activate the right-hand indicator; deactivate the right-hand indicator; activate the left-hand indicator; deactivate the left-hand indicator; I was looking at the 2008 Ford F-350 Owner Guide and it shows : " This switch is located on the passenger's side of the instrument panel . Open the front passenger door and remove the small access The inertia switch is located in the cab, generally under the dashboard on the right side. It is designed to open the fuel pump power circuit in the event of a collision. The switch is reset by pushing each of 2 buttons on the switch simultaneously (some models use switches with only one reset button). On the 2008-2010 Ford F-250, This switch is located on the passenger’s side of the instrument panel. Open the front passenger door and remove the small access panel. Make sure to turn off your vehicle. Pushing in the Fuel pump shut-off (inertia) switch. Turn the ignition to the ON position (Do not turn the ignition to ‘START) and wait a few 96 Cobra Fuel pump relay. The other night, I was driving on the freeway and suddenly lost all fuel pressure, resulting in a tow home. Per the shop electrical troubleshooting manual, there are two relays in series between the Fuel Pump Fuse and the Inertia Fuel Shutoff Switch (which is closed, BTW). The first relay is in the Constant Control Module.

ford fuel cut off switch