To turn off your iPhone X, XS, XS Max, or XR, simultaneously press and hold either volume button and the side button until slide to power off appears on the display. Slide the white and red power icon from left to right to shut down your iPhone. Wait a few moments, then press and hold the side button to turn your iPhone on again. Go to Settings → Face ID & Passcode. Enter your passcode. If your Face ID is already set up, toggle on everything under the Use Face ID For section. If not, tap Set up Face ID and follow the onscreen instructions. 2. Allow Face ID in third-party apps on your iPhone. Fix Face ID not working after screen replacement. If you’ve had your screen replaced, and the replacement was done by a third-party repair service, Face ID has been blocked on your device. This isn’t a problem with the repair work that has been done. This is a ‘check’ that Apple has placed on screen repair. for iPhone 11 PRO OLED Screen Replacement 5.8“ (A2160, A2217, A2215),with True Tone Repair,face ID,3D Touch Screen Repair Kit with Repair Tools,Screen Protector,Instructions 61 $56.99 $ 56 . 99 0:25 Face ID works best when your iPhone or iPad is approximately 10–20 inches from your face. To set up Face ID: Go to Settings, then tap Face ID & Passcode. If asked, enter your passcode. If you didn’t set a passcode, you’ll be asked to create one to use as an alternate way to verify your identity. Tap Set Up Face ID. Pry open the glass cover with a blade. We can see that there are many holes on the flood illuminator that are arranged in a matrix of 11x11. The chip is connected to the circuit board with the help of gold wires. Once water damaged, these holes can be blocked. And you will be faced up with Face ID failure. vjjU. Same here on a 13 Pro Max. It stopped working, so I reset Face-ID, face not recognised on setup try. Called Apple Support for a replacement. Day after, able to setup Face-ID again. Worked for 1hr. then iPhone didn't check Face-ID but asked for PIN/PW again. Reset Face-ID, face not recognised on next Face-ID setup try. Swapped screens back and True Tone option reappeared. From what I can tell online there are some vendors who have the tools (like Apple) to copy over the screen data from the old OEM to the new OEM screen, and it returns the True Tone option. This appears to only work on OEM replacements. Page Contents. Fix: iPhone 13, 13 Pro, and 13 Pro Max Face ID Stopped Working After New Update. Method 1: Check Face ID settings. Method 2: Remove and reset Face ID. Method 3: Add an alternate appearance. Method 4: Clean the Camera area. Method 5: Wipe and reset your phone. Method 6: Take it the pros. Conclusions. Photo by Vjeran Pavic / The Verge. Soon after the iPhone 13 launched, repair experts found that swapping out iPhone 13 screens would break Face ID unless you also moved over a tiny control chip Not an expert, but my phone had the same problem and I’m pretty sure since the LCD is still attached to the phone, all you need to do is apply some sort of adhesive or glue to reattach the digitizer and lcd. Just make sure the phone is off before hand. Pale_Cryptographer82 • 2 yr. ago. I was able to use superglue & it worked. Enter your Apple ID password to confirm. Open iTunes on the Mac or PC that you regularly back up to. Connect your device using the original lightning cable if available. Select your iPhone in iTunes. Select Restore Backup. Look at the date and size of each backup and pick the most recent backup where Face ID worked.

iphone 11 pro face id not working after screen replacement